Another flintlockers tool. I made a simple, small knapping tool.
SUPPLIES NEEDED: A 2 inch length of 1/4" OD copper tubing, and an antler tine.
TO MAKE; Tap one end together until the opposite sides touch. Use a punch to put a dent on the center of the flat edge. Fold it over until the opposite edges touch forming a small "V" shape where the open ends of the "V" touch. Drill a hole in the tine to accept the copper tube rounded end. Put it into the tine using epoxy or some adhesive.
TO USE IT: Press the center of the "V", applying pressure, against the front of your flint. Push in and twist down quickly. This causes small chipping flakes. Walk it across the front of the flint doing this.
After sharpening, shoot away!