[happycowboy]

Ok folks, i picked up an 1858 remington for dirt cheap this weekend. Dirt cheap because the guy shot and didn't clean it right away. When he did decide to clean it, he broke off the T-part on the end of the cylinder pin. So my question is how and the world can i get the cylinder pin out without the T-part on the end to pull or even tap on with a hammer. The pin is flush with frame. I'm pretty sure the gun could be made shootable again if i could get the cylinder pin out, so i could get the cylinder itself out and give the gun a good cleaning. Hopefully i can get this gun working again. Any and all suggestions would be greatly appreciated. Thanks folks.