[skeet]

Went to a gun show last weekend to get rid of a bunch of that stuff from the estate that the fellow died in the fire. There was a bunch of powders etc from the darn thing. 14 lbs were never opened. and another 8 lbs of Black. I gave a bunch of the black to a friend who had a cannon and 2 mortars...One shoots a golf ball the other a bowling ball...the cannon shoots small soft drink cans with a bit of cement in them. Some I kept as it was that expensive(at least here) Swiss powder. I found a bunch of new flints and almost a 1000 musket caps(CCI). Anyway I took lots of that stuff to that show. I sold all cheap and sold 80% of what I took. Was really glad to get it gone. The bad(or good in my opinion) thing is I went in the door and the first table in the place had my almost Holy Grail gun. Have been looking for a S&W Model 16-4 revolver in 32 H&R mag. There was a six inch one in beautiful condition. For just a bit shy of 1700 bucks... Talked to the fellow and got him down to 1500...but wow..a lot of money from my small stash. So told him I had to think it over. Went across the aisle and down 2 tables and there WAS the holy grail..a 4 inch 16-4. Asked if I could look at it. Fellow said sure. Hang tag was 1070 dollars less that the other guns..$625-...doing something out of character for me....I told the fellow I will take it. I turned down 1800 for it later that day. They didn't make many 4 inch guns. The fellow I do some shows with is legally blind(for driving anyway) and has been looking for a Ruger single action in 45 Colt. The fellow had one of them also as well as a factory engraved 41 mag. I talked my friend into buying the 45(it was a flat top with custom grips) as the gun was pristine and the grips looked like Mammoth ivory...with some age cracks and coloration. After we took em off the gun to check...turns out I was right for a change. Tag on the back with the makers name and material. Did some checking and the grips cost more than he paid for the gun. We both did well at that fellows table. I have ordered a reamer so I can cut the chambers on the S&W to 327 Federal. Doesn't really hurt the value and I can shoot any 32 straight cased ammo in it...I also have a Freedom Arms Single Action I bought last year in 32-20 with an extra cylinder in 32 H&R mag. So I'll cut those chambers out on it too. Now I am going to stop buying guns...again. Honest!!