|
|
#1
08-26-2009, 05:50 PM
|
|||
|
|||
|
No Drilling/Tapping Scope Mount for Ruger Blackhawk
I have been thinking aobut putting either a low-power scope or maybe a red dot sight on my 7-1/2" barreled .45 Colt Ruger Blackhawk. I would prefer not to use a mount that requires drilling and tapping and/or other permanent modifications in case I decide later on that I don't like such a set up. Is B-Square the only company that makes a "no gunsmithing required" mount for the Blackhawk? Has anyone used the B-Square mount and, if so, how do you like it?
|
|
#4
08-30-2009, 03:04 PM
|
|||
|
|||
|
I have never used the B-Squared mount, but was considering get one years back. The only reason I did not is because I heard from too many places that they would not hold point of aim, especially with heavy hunting loads. I never did mount a scope on any of my Black Hawks for that reason. I bought a Red Hawk and scoped it.
__________________
Catfish
|
|
#5
11-18-2009, 01:43 AM
|
||||
|
||||
|
Wow! How ironic... I just today bought a very nice .44mag 7.5" BBL, SuperBlackhawk. I didnt have time before work, to put it on my permit. Ill take care of that tomorrow.
Im going to be sure to follow this thread.
__________________
Greg
|
|
#6
11-18-2009, 09:42 AM
|
|||
|
|||
|
Quote:
|
|
#7
11-19-2009, 03:17 PM
|
|||
|
|||
|
Like I said, I have never used one, but at the time I was looking at them I had already killed at least 10 deer with iron sights. If you do try them give them alot of rough treatment before you take them hunting. Better safe than sorry.
__________________
Catfish
|
 |
|
|
Linear Mode
