|
|
#16
02-28-2014, 07:50 AM
|
|||
|
|||
|
Relief cuts
I guess I should make it clear that the relief cuts on the bullets just reduced bearing surface in the barrel. less bearing surface in the bore equates to lower pressure I have been told that some of the A frame bullets have been looked at as having too much bearing surface too. Remains to be seen if they are going to use the usual route to reduce pressures. Looking at some of their loading data ...wow.
__________________
skeet@huntchat.com Democracy is two wolves and a lamb voting on what to have for lunch. Liberty is a well-armed lamb contesting the vote!" Benjamin Franklin 
|
|
#17
02-28-2014, 08:18 AM
|
|||
|
|||
|
The relief cut is really obvious on the old Partitions, you won't mistake it for anything else. The old Partitions also did have very light machine marks on the exterior. You might not notice the machine marks unless you are looking for them, but on close examination, it's obvious they were made on a screw machine, if you are familiar with screw machine work.
__________________
“May we never confuse honest dissent with disloyal subversion.” Dwight D. Eisenhower "If the freedom of speech is taken away, then dumb and silent we may be led, like sheep to the slaughter" George Washington Jack@huntchat.com
|
|
#18
02-28-2014, 01:59 PM
|
||||
|
||||
|
Ok, I will take a look at my partition bullets tonight. I have never opened the boxes.
Ed
__________________
The three Rs: Respect for self; Respect for others; and responsibility for all your actions. "Is life so dear, or peace so sweet, as to be purchased at the price of chains and slavery? Forbid it, almighty God! I know not what course others may take, but as for me, give me liberty, or give me death!"
|
 |
|
|
Linear Mode
