Hunt Chat  

Go Back   Hunt Chat > Tools of the Trade > Reloading Bench

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 01-17-2008, 01:53 AM
Rustywreck Rustywreck is offline
Moderator
 
Join Date: Jun 2002
Location: Solon Springs, WI
Posts: 546
sucesss!! well, sorta

After finally getting my press set up an reloading a few cartridges (47 to be exact) I shot them off and lived to tell about it!!

I had three different powder loads at 100 yards.
The first load had 5 shots in a 1" X 1.5" group.
The second load had 7 shots in a 1.25" X 1.25" group.
The third group was a bit more spread out, but still in 1.25" X 1.25" range.

I don't know how I should be measuring groups. What I did was measure a square that enclosed all the shot in a group. The weather wasn't too bad, about 20 degrees and a little wind from the left - if felt colder than it was.

The next time I'll be able to shoot will be Saturday with a high temperature of -6 degrees.

I'm still going to do some experimenting with a different powder and different case.

So my question of the day is: If a particular cartidge load shoots well at 100 yards, will it be proportionally good at 200 yards, or can it go all to heck?

Thanks again to everyone who helped me get to this point, but don't think you're done yet...
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 01:56 AM.


Powered by vBulletin® Version
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.