|
|
#1
10-06-2006, 02:56 AM
|
|||
|
|||
|
Reloading the Hornet, K-Hornet, and their wildcats .......
Can't remember where I read about loading this case, but a poster commented about his problems and frustration of only getting 2-3 loadings per case.
He was over-working the brass. My question is How does one reload this brass without exerting too much stress on the thin case neck, causing it to prematurely crack/split? Best two ideas I came up with was (one) to start reloading with factory loads shot in the firearm I'd be reloading for and only neck size, or (two) use a .17 caliber decapping pin for depriming, and resize the case using a body die, then a neck sizing die. Suggestions? THANKS! [COLOR=BLUE]10/10 -- Any other inputs? Please?[/BLUE] 
__________________
I would rather hunt with Dick Cheney than ride in Ted Kennedy's automobile. POLITICAL CORRECTNESS is nothing more than cowardice, group-think and liberal censorship! Last edited by Brant Buster; 10-10-2006 at 08:27 PM. 
|
|
|
Threaded Mode