Hunt Chat  

Go Back   Hunt Chat > Tools of the Trade > Handguns & Concealed Carry

Reply
 
Thread Tools Display Modes
  #1  
Old 01-29-2006, 06:39 PM
HANDGUNNER HANDGUNNER is offline
 
Join Date: Aug 2005
Location: NEW HAMPSHIRE
Posts: 63
Glock 20/21 question

I'm fixin to buy a Glock 20 in 10mm, but the grip is a bit big and I'm wondering if any of you have experience with this glock frame. When I first picked it up it felt a little awkward , but I was wondering if you get use to it. Any info would be greately appreciated.
__________________
HANDGUNNER
Reply With Quote
  #2  
Old 03-23-2006, 04:24 PM
hunterdeneugene hunterdeneugene is offline
 
Join Date: Mar 2006
Location: NY
Posts: 1
glock makes an awesome gun. I have a 22 and a 23 in 40 s&w and love them both. The grip on the 20/21 is a little bigger but not much. Try the new model with the molded fingergrooves.
__________________
2 0n 8 low
Reply With Quote
  #3  
Old 04-05-2006, 06:50 PM
Esox357 Esox357 is offline
Registered User
 
Join Date: Oct 2002
Location: Where Men Are Men And Cows Are Afraid......Nebraska
Posts: 86
If it feels to big than it probably is that is the problem with the 45 double stack. I love glocks but the grip for the 45 and 10 is a little large, I could get by with it but I prefer my 40's.
Ultimately if I were you I would try to rent one at the range or find someone that will let you shoot theres.
The glock 21 is a sweet firearm and very accurate as well, but it is a little large, I think the model 36 that glock makes is a single stack that would allow the grip size to be smaller, that may be another option. I don't know if it is a mental thing or not but the G-30 has the same circumference grip but is shorter lengthwise which to me makes it feel smaller and the g-30 is a awesome compact 45. Esox357
Reply With Quote
  #4  
Old 04-13-2006, 10:03 PM
RASteele RASteele is offline
 
Join Date: Jan 2001
Location: Albuquerque, NM
Posts: 35
I own an early model ('94ish) Glock 20... pre-molded finger rises. Yeah, it's a little bulky, but the power (v. .40S&W and .45ACP) and flat shooting (v. .45ACP) make it worth while. It's a fine weapon that I have used for Law Enforcement duty, hunting javalina in Texas, and carried when I go hiking, hunting, or traveling cross-country. I've put 15+ thousand rounds through it and it still fires like a champ (2,000 [give-or-take] of those were "ultra-hot" handloaded 200gr. FMJs traveling at around 1330fps [had those as bear or cougar "repellent" when I lived in North Carolina]).

I'm curious, though: Why the Glock? If you are looking for high capacity, I understand. But if you want a pistol chambered for the under-rated and over-looked 10mm that fits better in your hand, why not try a Colt Delta Elite or similar 1911 framed pistol? The grip on it is far more "friendly", allowing for better accuracy and shot placement. (I recently picked one up to be able to accessorize the bee-jeezus out of and it's a fine shooter! Can't wait 'till I'm done to see how it fires then!!!)

Outside of that information, the only tip I can give is start handloading or get in the good graces of someone who does, because anything that you can get commercially is loaded to the same or similar strength of a .40S&W (known as the ".40 Short & Weak" to true 10 fans). That's like firing nothing but .38 Specials out of a .357 Magnum. What's the point of owning the Magnum then? The 10 pistol is built to withstand higher tolerances than the .40, but the ammunition has been loaded down -commercially- to appease the more "tender" consumer. (Info tid-bit: The FBI wanted to use the 10mm for all of their Agents in the late '80s, but the majority of the Agents [fair men and women and desk-jockies] couldn't handle the recoil. The FBI then contracted with Smith & Wesson to create a new round using a same diameter bullet, same case width but shortened, and less powder to create a "less shooter-battering" round. Enter the birth of the .40 Short and Weak. And, unless I am mistaken, it was the first time a pistol cartridge was ever redesigned for the sole purpose of making a *less* powerful round, instead of *more* powerful round. [Revolver rounds redesigned to create rounds for automatics are, obvioulsy, ruled out.])

(I just read the above portion of this to my wife who asked, "Are you going to get a group of people together, have them wear sheets and chant "10mm is Great" for 20 minutes of every hour?" My reply: "... I might.")

I guess after all is said and done with my Pro-10mm Rant, the answer is: You may get used to the grip, you may not. It depends on you and the size of your hands. Practice holding and aiming the weapon at a spot on the wall until, when you pick it up or pull it from your holster, your hand knows exactly where to go and be on the weapon to be able to make that shot true.
__________________
Good luck and shoot safely.
Reply With Quote
Reply

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 06:10 PM.


Powered by vBulletin® Version
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.