Hunt Chat  

Go Back   Hunt Chat > Tools of the Trade > Knives and Blades

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
  #1  
Old 05-12-2014, 06:10 AM
Rancid Crabtree Rancid Crabtree is offline
Registered User
 
Join Date: Jul 2008
Location: WI
Posts: 191
Knife from a saw blade

This blade is over an 1/8 of an inch thick. I am using a 24 inch diameter concrete saw blade.



I cut a chunk of it away with a angle grinder.



This will be a hunting knife with a drop point and a finger guard.



This is a very thick blade.





Next, I heated the blade cherry red and let it cool very slowly to soften the steel. so I could drill hole and grind a bevel and do some file work.



this time I am going to do a "W" pattern on the backbone of the blade. I marked off the spacing with a sharpie.



Then I used a small square file on one side of the blade.



Then turned the blade around and did the other side.



I added a little bluing to bring out the details.





With all the file work done, I heat treated the blade by heating it until it was non magnetic (around 1500F) and then quenched it in 130F salt water. Next I temper it at 400F for one hour. Finally I polish the blade to a mirror finish.

I used curly maple and aluminum pins. I'm calling it "Blonde"









__________________
http://staysharpguide.com/
Reply With Quote
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -5. The time now is 03:49 PM.


Powered by vBulletin® Version
Copyright ©2000 - 2013, Jelsoft Enterprises Ltd.