|
|
#1
05-05-2009, 09:42 AM
|
|||
|
|||
|
303 mounts
How do I mount a scope on a British .303.
Is there a mount available? 
|
|
#3
05-05-2009, 02:39 PM
|
|||
|
|||
|
As Wrenchman says, B Square makes a mount that doesn't require drilling.
If you want other options, look through Brownell's or Midway's website (or catalog) at the list of scope mounts. I think you'll find something for your rifle.
__________________
“May we never confuse honest dissent with disloyal subversion.” Dwight D. Eisenhower "If the freedom of speech is taken away, then dumb and silent we may be led, like sheep to the slaughter" George Washington Jack@huntchat.com
|
|
#4
05-08-2009, 12:16 PM
|
||||
|
||||
|
Weaver makes a mount T0 1, this fits certian models of the .303 Enfield, but you must have it drilled and taped. It's only draw back is that it only provides a grooved aluminum base (3/8").
Before I gave back the .303 I had trouble with, I used two sets of Leupold aluminum tip-off (split rings) to anchor my VX-II(two front, two back), and in theory it worked, but with the worn barrel and super bad key-holein', I am not sure how sound it was. But if I ever get another .303 that might be a bit better in the accuracy department, I would try it one more time.
__________________
I tell you I don't get no respect. Why, the surgeon general, he offered me a cigarette. (Rodney)
|
|
#5
11-10-2009, 09:40 AM
|
|||
|
|||
|
Hmm bet you were shooting Boat tailed bullets
 most 303's don't like them and shoot much better with flat based bulelts.
__________________
"Don't let the bastards grind you down"
|
 |
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
