#1
|
|||
|
|||
7.62N vs .308 win
Mil 7.62X51 (7.62 NATO) is specked to higher pressures than SAMI specs.
__________________
A retired bum, Opinionated Old Fart living happily in Free Wyoming. Never go any where unarmed, it's your right as an American. Only from my cold dead hands could you take my guns: C. Heston & I. Vote freedom first, last and always! Molon Labe! Life NAHC. NRA (Endowment). Officer: Wyoming State Shooting Association, Member: WSSA, Blue Ribbon Coalition (BRC), GOA, RKBA , JFPO. Founder: Wyoming Off Road Vehicle Association: Access, access, access! Fair public access for all to all public lands on or off wheels. Tick (Pi$$) a liberal off TODAY and every day !! Elitests SUCK! |
#2
|
|||
|
|||
You are correct
hnter,
This topic comes up from time to time. The link below covers the subject very well. All the best... Gil http://www.thegunzone.com/30cal.html |
#3
|
|||
|
|||
hnter,
I just read Gil's link and it seems there is not any standardization even among NATO nations about the 7.62 NATO round each produces. I have heard various comments about the .308 Winchester and 7.62x51mm rounds. On page 56 of the 9th Edition of the book, "Cartridges of the World" it says, "Historical Notes: (for the .308 Winchester) Introduced by Winchester as a new sporting cartridge in 1952, the .308 is nothing more than the NATO 7.62x51mm military round." Personally, I have had two Match M14s in my life and have several .308 rifles, one is a Remington Varmit .308. Among the M14s, Remingtons and two Indian .308/7.62x51mm arms, I have shot Factory .308 ammo as well as lots of US GI Ball (LC 69 and LC 70) through them all and have never noticed any problems, real or imagined. I think COTW is correct on page 56. I have yet to see a box of Factory .308 Winchester caliber hunting ammo with a warning: "Do not fire in a 7.62x51mm arm." (Or vice versa) My M14s would have been non-compliant in any event since they shot lots of US Factory .308 Winchester ammo, they just did not know they were 7.62 NATO. Whatever. Adam
__________________
Adam Helmer Last edited by Adam Helmer; 11-11-2006 at 03:14 PM. |
|
|