|
|
#1
10-30-2008, 08:38 PM
|
|||
|
|||
|
marking cases
anyone know if i mark the bottom of my cases with a marker if that would cause any problems. I need to be able to tell the difference because i have two rifles in the same caliber.
PS i tried using different primmers but my groups changed. 
|
|
#3
10-30-2008, 11:27 PM
|
|||
|
|||
|
Red sharpie on my 260s for my M700 and Black for the M84 Kimber. I`ve 2 rifles chambered for the `06 I do the same with, and had 3, 708s at one time.
It`s helpful as h#$$ well when you`re as dense as I am at times.
__________________
I must confess, I was born at a very early age. --Groucho Marx
|
|
#4
10-31-2008, 09:42 AM
|
||||
|
||||
|
Yuppers. Color the whole base if you have to separate brass, or just the primers if you can switch cases, but need to have different loads.
BTW, if you degrease and dip just the rim area of cases into most cold-blue liquids, the brass will turn a permanent black.
__________________
Freedom of the Press Does NOT mean the right to lie! Visit me at my Reloading Room webpage! Get signed copies of my Vietnam novels at "Baggy Zero Four" "Mike Five Eight"
|
|
#5
10-31-2008, 12:24 PM
|
|||
|
|||
|
One thing to note about marking cases with a marking pen (I use a Sharpie also): tumbling the case will take the marking off.
Haven't marked cases with cold blue, so I don't know if that comes off, too.
__________________
“May we never confuse honest dissent with disloyal subversion.” Dwight D. Eisenhower "If the freedom of speech is taken away, then dumb and silent we may be led, like sheep to the slaughter" George Washington Jack@huntchat.com
|
 |
|
|
Linear Mode
