|
|
|
|
#1
02-03-2010, 10:13 PM
|
||||
|
||||
|
Yeah, I know it'd cost more but its more about having a project to do. Everyone thinks that Cooeys are such crappy, cheap old guns. I'd like to see what one could do if a guy souped it up. And yes the HMR is faster, flatter, and more common, but I dont know where I'd find a cheap Cooey .22Mag. As far as I know they were only .22LR, L, S. I just wanna know how the barrels are attached to the reciever. Are they screwed in or clamped or what?
__________________
Happiness is a full clip. 
|
|
#2
02-03-2010, 11:05 PM
|
||||
|
||||
|
They are fine old guns.. I have 2 or 3 cooey .22's in my gun cabinet, and a couple shotguns..
I couldn't tell you how the barrel was installed or not...
__________________
It doesn't matter what you hunt, as long as you hunt <hr> Member - AOPA - Lloydminster & Area Archery Assoc. - Life Member NAHC - IBEP Instructor
|
|
#3
02-04-2010, 05:37 AM
|
|||
|
|||
|
Most basic .22 rifles have their barrels pressed in and secured with a pin or set screw. Once the pin is removed, the barrel is clamped in a padded vise and the receiver carefully tapped backward and off. Age and rust can make this difficult.
I know nothing about Cooeys - a new barrel in .17HM2 would likely need it's chamber end machined to fit the receiver. Easy enough for a good gunsmith or talented hobbiest with a lathe.
|
 |
|
|
Hybrid Mode
