|
|
#1
09-09-2005, 12:26 AM
|
||||
|
||||
|
Need Marlin info
I have a Marlin 336 SC 30-30 and I think the firing pin is busted. I took it out shooting the other day and it didn't go boom. I looked at the primers and they didn't have even the slightest dent in them. I'd like to try and fix it myself but the only way to get a manual is to snail-mail Marlin and request one and I don't want to wait that long cuz I'm hoping to hunt with it this year. Any suggestions on where to get disassembly instructions?
__________________
USAF Retired  Far better is it to dare mighty things, to win glorius triumphs, even though checkered by failure... than to rank with those poor spirits who neither enjoy nor suffer much, because they live in a gray twilight that knows not victory nor defeat. Theodore Roosevelt Don't sweat the petty things and don't pet the sweaty things 
|
|
#2
09-09-2005, 10:38 AM
|
|||
|
|||
|
Here goes: Open lever part way, seeing that chamber is empty remove the screw that retains the lever to the action. Now keep opening the lever and bring the bolt to the rear. Drop lever out and pull bolt out, hold down on the hammer while doing this. On the inside of the frames left side is an ejector, it fits in a slot with a knob projecting into the appropiate hole in the receiver, set this aside. The firing pin is of a two piece design, push the short rear piece up and use a punch to push the whole assembley for ward. The firing pin should protrude through the front of the bolt. If it does, I don't think there is anything wrong with the FP. Now to reassemble just reverse the order, Make Sure you get the ejector in the proper position. I hold back on the hammer when inserting the bolt, once it is properly lined up slide the bolt in far enough to depress the ejector. Insert the lever up through the slot and make sure it engages the bolt, you can operate it slowly to make sure. Now replace the lever screw. I'v done this a couple of hundred times, but get a mental blocktryint to put it in writing. Good Luck it's not that hard.
|
|
#4
09-09-2005, 07:10 PM
|
||||
|
||||
|
Funny guy
__________________
USAF Retired Far better is it to dare mighty things, to win glorius triumphs, even though checkered by failure... than to rank with those poor spirits who neither enjoy nor suffer much, because they live in a gray twilight that knows not victory nor defeat. Theodore Roosevelt Don't sweat the petty things and don't pet the sweaty things
|
|
#5
09-09-2005, 09:10 PM
|
||||
|
||||
|
Should I be able to see the firing pin while the bolt is still installed? Should there be tension on the pin (or whatever it's called) that the hammer strikes at the rear of the bolt?
__________________
USAF Retired Far better is it to dare mighty things, to win glorius triumphs, even though checkered by failure... than to rank with those poor spirits who neither enjoy nor suffer much, because they live in a gray twilight that knows not victory nor defeat. Theodore Roosevelt Don't sweat the petty things and don't pet the sweaty things
|
|
#6
09-09-2005, 09:26 PM
|
|||
|
|||
|
Not really, because of the two piece design. The rear section has to be pushed up and aligned with the firing pin so you can push it forward and see if it prutudes from the bolt. Now repeat after me, It's as easy as falling off a log.
|
 |
|
|
Linear Mode
