|
|
#1
09-12-2012, 03:41 PM
|
||||
|
||||
|
S&W M-19 parts order
I just ordered 4 parts for a M-19-3 from Gun Parts off the internet and their schematic with their parts numbers.
What I received was standard K frame parts like for a M-10 or a 15. Three of the 4 parts were wrong. I am trying to get in contact with them to find out, if in fact they have the right 19 parts or if I return the parts and re-order will I just get the same wrong generic K frame parts again. This is just a heads up about G-P and their generic bin parts deal, careful is the word. Right now I am down to finding one part, the correct center pin for a 19, which has the collar set back from the rounded end, about .200 further than a 38spl K frame center pin, to make up for length difference of the 357 cylinder. Ed
__________________
The three Rs: Respect for self; Respect for others; and responsibility for all your actions. "Is life so dear, or peace so sweet, as to be purchased at the price of chains and slavery? Forbid it, almighty God! I know not what course others may take, but as for me, give me liberty, or give me death!" 
|
|
#2
09-13-2012, 08:56 AM
|
|||
|
|||
|
I'm really not suprised. Just so many s&w parts. Then again some just don't care.
|
|
#3
09-18-2012, 07:31 PM
|
|||
|
|||
|
If no luck there, order the parts from Brownells. We use them befor all others if they have the part needed.
__________________
VFW Life Member, NRA Life Member, Wisconsin Conservation Warden Assoc. Life Member, Wisconsin Waterfowl Assoc. Life Member
|
|
#4
09-19-2012, 09:59 AM
|
||||
|
||||
|
I had to order some new screwdriver bits today so ordered a center pin from Brownell's It says in the data that the 66/19 takes this pin as does the 10 and 15 so we shall see. I suspect it will be as the G-P center pin, too short as they are not the same pins. But at half price to G-P I thought I would give it a try.
Ed PS: This morning, the 21st, I got an email from G-P saying they shipped my pin. We will see which one, if any is the right one.
__________________
The three Rs: Respect for self; Respect for others; and responsibility for all your actions. "Is life so dear, or peace so sweet, as to be purchased at the price of chains and slavery? Forbid it, almighty God! I know not what course others may take, but as for me, give me liberty, or give me death!" Last edited by Rapier; 09-21-2012 at 12:11 PM.
|
|
#5
09-25-2012, 06:49 AM
|
||||
|
||||
|
Yesterday the 24th I received both center pins one in the morning and one in the afternoon, one from G-P and one from Brownells, now these are the 4th pins I have received. The pin from Brownells was a K frame pin and not a pin for a M-19. The G-P pin was marked as being for a K-38 Outdoorsman and M & P with a different number but it was the correct center pin for the M-19.
To be fair, I returned the G-P part to start with and wrote a detailed description of what I wanted so obviously the folks at G-P went and found it. Now this old pinned barrel, recessed chamber M-19, 4 inch with about 95-97% bright blue finish functions as new and has gone to join its brothers in the safe. As I was working on this gun I discovered that the blued M-19 and the stainless 66 have taken another $100 jump in value. Ed
__________________
The three Rs: Respect for self; Respect for others; and responsibility for all your actions. "Is life so dear, or peace so sweet, as to be purchased at the price of chains and slavery? Forbid it, almighty God! I know not what course others may take, but as for me, give me liberty, or give me death!"
|
 |
|
|
Linear Mode
